Hayabusa Drag Racing Lowering Triple Tree

Clean Smooth Lines along with the Matte Grey Finish and Laser Etching make for a Clean and Fast Looking Piece

Lowers the front end without the use of tie down straps by allowing the fork tube to slide through the triple tree clamps.

P-Lock-On-Off Laser Etched Markings

This triple tree has the most clearance of any Hayabusa Lowering Triple Tree on the market. Your Levers and Mastercylinders will Not rub when installed. This also makes installation allot less difficult. Most Lowering Triple Trees do not have enough clearance and will rub when installed on 2008-Up models. If they do not rub then installation has to be just right and the levers are very very close. Not with our triple tree, installation is a breeze and everything will fit perfectly.

Attention!!

This Top Clamp Is Far Superior To Most On The Market Today Read Below To Understand Why

The design is the result of our experience with several different manufacturers over the past several years. The quality of this piece is exceptional and offered at a much lower price than any comparable piece anywhere. Your handle bars will slide into the 6061 aluminum clamp smoothly and are held in buy the provided stainless steel hardware. Unlike others this clamp utilizes the groove in the bottom of your handle bar to allow the bolt to hold your handle bars in place the same as the OEM set up. Many other clamps require you to literally force your handle bars into the clamp using a hammer. Then are held in place only by the pinch bolts compressing the bar. Worse yet China made clamps have flooded the market. Manufactured of cast aluminum and then CNC Machined to look like they are Billet but in reality they are very very poor quality and dangerous to use on a motorcycle. Learn from our experience and buy the best quality pieces at the best prices in the industry!

Fits The Following Suzuki Models:
All Years Hayabusa